What are the installation methods for 3 sides veneer wood slat panel?

Real Wood Slat Panel launches handy installation guide for Wood Slat Panel

The wood slat panel manufacturer has recently released a handy installation guide for Real wood slat panels, designed to help make installation easy and ensure the product's stability and aesthetics during use. Below are a few common installation methods and their steps:

 Direct fixing method

Step 1: Measurement and Marking

First, use a tape measure to measure the dimensions of the wall and mark the installation position on the wall. Make sure all lines are vertical and level to ensure the final installation.

Step 2: Drill holes and install screws

Drill holes according to the marked locations and pre-install the plastic expansion tubes. Next, align one edge of the batten with the marked line and use screws to fix the batten to the wall. Take care to keep the spacing between the strips even and consistent.

Step 3: Connecting the slats

Continue to attach the next batten, making sure it fits snugly against the previous one, and secure it with the screws. Repeat this process until all slats have been installed.

 Concealed Rail System

Step 1: Installing the track

First, install the hidden track on the wall. The track needs to be pre-cut to the right length and fixed to the wall with screws. The position of the track should be parallel to the direction of installation of the slats.

Step 2: Install the slats

Insert the batten into the hidden track and gently push it in until it snaps into place. Continue installing the remaining batten boards, making sure that each board is properly seated within the track.

Step 3: Finishing touches

Finally, check that all the batten boards are securely installed in the track and make any necessary adjustments. If necessary, use edging strips or other trim pieces to cover the ends of the track for added aesthetics.

 Glueing Method

Step 1: Prepare the glue

Choose a strong glue suitable for the texture of the wood and prepare the right amount of glue according to the instructions.

Step 2: Apply glue

Apply an even layer of glue to the back of the slats, making sure to spread the glue over a large enough area to ensure bonding strength.

Step 3: Fixing the slats

Quickly attach the glued batten to the wall and press it down with your hand for a few seconds to make sure it is in tight contact with the wall. Continue installing the remaining batten boards and use clamps as needed to temporarily hold them in place until the glue is completely dry.

 Caution.

- Always wear the necessary personal protective equipment, such as gloves and goggles, during installation.

- For large or complex installation projects, it is recommended to seek professional assistance.

- After installation, check that all wood slats are secure and make any necessary adjustments.

3 Sides Veneer Wood Slat Panel manufacturer said that this installation guide is launched to help users better understand and master the installation techniques of Real wood slat panel, and to ensure the product's beauty and stability in use. In the future, wood slat panel will continue to be committed to provide more comprehensive installation guidance and support services.